wxb inlet manifold

sparkyshep · Post by **sparkyshep** » Thu Oct 23, 2003 5:23 pm

can any one advise me of a supplyer of a inlet manifold for my 2.1 wxb engine i wish to run either weber idf,s or dcnf or ida,s but they are a bit pricey for me please help as i looked at a type 1 manifold and the inlet ports where a lot smaller thane my wbx also are type 4 lifters the same size as type 5 lifters

Wally · Post by **Wally** » Sun Oct 26, 2003 11:58 pm

Hi,
Bernd Ahnendorp (www.ahnendorp.com) stocks manifolds for the wbx heads to IDF/DLRA stud pattern. They may not be on the site tho.
Greetings,
Walter

sparkyshep · Post by **sparkyshep** » Mon Oct 27, 2003 9:32 am

thanks for the help on the manifold supplyer i will give them a try thanks steve

marcotheturbosteamengine · Tue Oct 28, 2003 1:33 am

use CBs big beef manifolds and port them, yes the T4,T5,T25 use the same lifter but not the same cams!

good luck

Shoptalkforums.com

wxb inlet manifold

wxb inlet manifold

re manifold