Nice turbo set up!

Orange65Turbo · Post by **Orange65Turbo** » Mon Nov 01, 2004 9:32 pm

http://www.pbase.com/550joe/image/15426314

Very Clean.

ecdez · Post by **ecdez** » Tue Nov 02, 2004 5:12 am

Man that looks good.

Bigwindow · Post by **Bigwindow** » Tue Dec 14, 2004 3:48 am

Looks awesome!!

Does anybody know where or whom made the header?
I have looked everywhere but can't find anyone who make these turbo-over-the-trans- type turbo header..

regards
Harald from Norway

brianwheelies · Post by **brianwheelies** » Tue Dec 14, 2004 4:42 pm

try this one
http://www.cbperformance.com/catalog.asp?ProductID=306

fortyeye · Post by **fortyeye** » Tue Dec 14, 2004 8:06 pm

brianwheelies wrote:try this one
http://www.cbperformance.com/catalog.asp?ProductID=306

Good eye

Bigwindow · Post by **Bigwindow** » Wed Dec 15, 2004 4:40 am

Thank you for answering, but I have looked at that one and it's not the same..

The Turbo-flange on the picture is pointing towards the driver and the header that cb sell is the turbo facing upwards. The WG flange is also located differently.

But it can be a modified cb header???

Bigwindow · Post by **Bigwindow** » Wed Dec 15, 2004 5:19 am

Never mind!

I think I found it! It's a modified mid-engine exhaust that originaly comes with a stinger!

Look:
http://www.cbperformance.com/catalog.asp?ProductID=374

vtec this · Post by **vtec this** » Thu Dec 16, 2004 5:47 pm

where did that Y-pipe come from? i need one of those
also, will that header work on my sedan because i would like a similar setup

Bigwindow · Post by **Bigwindow** » Fri Dec 17, 2004 5:28 pm

vtec this wrote:where did that Y-pipe come from? i need one of those
also, will that header work on my sedan because i would like a similar setup

The Y-pipe is also a cbperformance product..

I will use this kind og header in my sedan, but you will have to cut away the metal underneath the seat..In other words, you will have to cut away all the metal above the gearbox! As this header locates the turbo inside your car..

vtec this · Post by **vtec this** » Wed Dec 22, 2004 10:08 am

I dont want to hack up my car, so maybe i can locate the turbo along side the transmission, and go from there.

vwjim · Post by **vwjim** » Fri Jan 21, 2005 3:48 am

Orange65Turbo wrote:http://www.pbase.com/550joe/image/15426314

Very Clean.

Anyone know of somewhere with some good photo's of mid engine'd VW's with the bodies off, so I can see what modifications are needed to the chassis etc.

Cheers,

Jim

vwfye · Post by **vwfye** » Fri Jan 21, 2005 8:48 am

on my midengine type 3 the pan was shortend, new box steel runners were added to hold the tranny and the torson tube was welded into place. rear supports were added to the body with runners to the rear of the box steel subframe and they shock upper mounts were relocated. oh, then the battery was moved to under the rear trunk.

Shoptalkforums.com

Nice turbo set up!

Nice turbo set up!

Re: Nice turbo set up!