Have you guys seen this FI service?

[vwbill]

http://injectorservices.com/injectserv.htm

bill

[raygreenwood]

I have not seen that particular one...but that cost is awesome. I have the ability to do the same to my own and have been for a while. Its not all that hard. You need a small ultrasonic unit....some decent solvents.....and a good burrette.
I have just recently been disecting a few injectors...learning how to re-heat seal them and also removing the not just the plastic pintle caps byt teh crimped pintle orifice for inspection of angle , wear and rust at the pintle seat. I am experiementing with different pintle nozzles. Ray