Page 2 of 2
Re: Type 1 Wedgemate Crank into 2.1 WBX Case
Posted: Wed Oct 01, 2025 3:15 pm
by 23split
Photos
Re: Type 1 Wedgemate Crank into 2.1 WBX Case
Posted: Wed Feb 04, 2026 1:06 pm
by Piledriver
So early WBX case?,
What did you use for the rear main with thrusts? (has to be cut in half/use 2 bearings?)
The T4 case bore at flywheel end is much larger than T1.
Re: Type 1 Wedgemate Crank into 2.1 WBX Case
Posted: Wed Feb 04, 2026 1:47 pm
by 23split
Early 2.1 I believe.
Using a stock style VW one piece rear main/thrust. I'll dig out the numbers sometime soon.
This engine will run T1 sized journals in the WBX case.
Re: Type 1 Wedgemate Crank into 2.1 WBX Case
Posted: Wed Feb 04, 2026 1:49 pm
by 23split
Rear main
Re: Type 1 Wedgemate Crank into 2.1 WBX Case
Posted: Sat Feb 14, 2026 7:39 am
by 23split
Boring finally underway for the 4" barrels
Re: Type 1 Wedgemate Crank into 2.1 WBX Case
Posted: Sat Feb 14, 2026 7:43 am
by 23split
On the mill.....
