Shoptalkforums.com

Beezerbob wrote:Kits are available but where to get a float!?
I told my friend what a big boost in power one can get from a stock motor with a bug spray carb on a bus with single port heads!!

You can get new floats here: http://www.parts123.com/parts123/yb.dll ... e~cadegdha

Look under Holley 94 parts.

I was running a 300 cfm with an Edelbrock manifold back in the early 70's with great performance. Then again here in coastal San Diego we luckily don't get the cold / damp conditions that would have caused icing.
I thought Holley also made a buggyspray ( not bugspray) for off road applications. Yes , no maybe ?

I got a Holley carb book that told me just what passage to drill out , so as to eliminate that famous BOG ! when U step on it , WORKS GREAT! also that ice problem solved by a can of Heat!....good tip! Thanks

Preheat...modify your manifold as I did my Zenith. It only took a few hours to go from this:



To this:



And finally this:



You can also direct post-cylinder air into the air intake.

Kyle

ok thats pretty ingenious. im stealing that pic for the off road forum.

It's already there:

http://shoptalkforums.com/viewtopic.php?t=127879

I should qualify this by saying that I haven't actually tried it out yet...

Kyle

Had one in the seventies, Scat .410 lift/286 duration cam, Scat centrifical adv dist. 88's. Never had a problem.Would go the speedo in 2nd gear.

Hi, I'm new to the forum and am looking for help locating 2 Holley bug spray 6244 6244 200 cfm carburetors, if someone can point me in the direction of these I'd appreciate it.
Randy