Posted: Fri Jul 14, 2006 12:47 pm
Have you checked the VW dealer? The cost will prob. be one arm and a leg.
I am doing the same conversion myself.
But try Demello (DMS) for the cranks. They do these all the time.
good luck
Page 2 of 2
Posted: Sun Oct 22, 2006 1:10 pm
Posted: Tue Oct 24, 2006 1:25 am
In the UK a brand new VW wbx 2.1 crank was about 300 pounds..
Aircooled net do counterweighted wbx cranks and stojers too... IIRC
Aircooled net do counterweighted wbx cranks and stojers too... IIRC
Posted: Fri Aug 17, 2007 5:00 am
Hello,
I can supply a WBX couterwieghted crank.
Ben
I can supply a WBX couterwieghted crank.
Ben
Posted: Sat Aug 18, 2007 4:12 am
And stroked?
But shipping will be a killer??? and then there is the import duty etc...
But shipping will be a killer??? and then there is the import duty etc...
Posted: Mon Aug 20, 2007 1:30 pm
Pay him and let him send it to you as a gift
That is how we do it sometimes here to get stuff from the states without paying impor- dut- to skip the import taxes
That is how we do it sometimes here to get stuff from the states without paying impor- dut- to skip the import taxes
Posted: Thu Aug 23, 2007 8:05 am
Yep Strokers no problem,
I have 2 x 86 cranks under construction now.
Ben
I have 2 x 86 cranks under construction now.
Ben
Posted: Mon Apr 20, 2009 9:19 am
So let me get this straight. All that has to be changed is the thrust bearing? so I guess you would use water boxer shims to set the end play?
Posted: Wed Apr 29, 2009 2:06 am
Hello
You need to modify the type 1 case to fit the three piece WBX bearing
then use WBX/ type 2 shims
regards
Ben Durie
You need to modify the type 1 case to fit the three piece WBX bearing
then use WBX/ type 2 shims
regards
Ben Durie
Posted: Wed Apr 29, 2009 4:32 pm
Hi Ben
thanks for this info, very helpful indeed.
thanks for this info, very helpful indeed.
Posted: Wed Apr 29, 2009 6:10 pm
Hey ben are you a crank builderBen Durie wrote:Yep Strokers no problem,
I have 2 x 86 cranks under construction now.
Ben
Posted: Thu Apr 30, 2009 1:20 am
Hello ,
I am not a crank builder, I use a guy in Melbourne to manufacture or modify some of my components including crankshafts
I am not a crank builder, I use a guy in Melbourne to manufacture or modify some of my components including crankshafts
Posted: Tue Jun 30, 2009 2:48 pm
DPR?
Matt Keene wrote:Hi guys. Clever stuff here about the seal. Where can you buy them? Also, do any of you guys know where I can buy a counter-weighted 76mm Wasser crank? Any help appreciated, matt