Page 1 of 1
FOOM
Posted: Sun Jun 11, 2006 1:33 am
by chug_A_bug
just one of those sleepless night, and thinking of the 69 GL if I were to put some really good exspanding Foom in the heater channels that would make the car stiffer right??
PROS.........CONS
Posted: Mon Jun 12, 2006 8:54 pm
by WD-40
I highly doubt it would make it ANY stiffer.
I have a car with expanding foam in the heater channels. The PO did it because he didn't want the drafts after he took the heater boxes out. Now, I can never have heat again unless I dig it all out (not easy).
Don't do it.
- David
Posted: Wed Jun 14, 2006 9:10 am
by Ozzie
WD-40 wrote:I highly doubt it would make it ANY stiffer.
I have a car with expanding foam in the heater channels. The PO did it because he didn't want the drafts after he took the heater boxes out. Now, I can never have heat again unless I dig it all out (not easy).
Don't do it.
- David
Gasoline will disolve it, and quick. I reccomend washing it out w/ soapwater afterwards.
Posted: Wed Jun 14, 2006 1:03 pm
by peterericb
heater channels already rust bad.. having something there holding the water in place isn't the best idea either.