Page 1 of 1
914 engine in type 2 bus?
Posted: Fri Feb 16, 2007 12:22 pm
by summerstrand
Does anyone have any info about fitting a 2.0l 914 engine into a 1967 splitty ? Thanks
Posted: Fri Feb 16, 2007 2:12 pm
by wildthings
I would post this on The Type 4rum under specialty forums, they are more into this.
Posted: Fri Feb 16, 2007 2:41 pm
by Pillow
Check out Jake Raby's DTM system. Google Raby's Aircooled Technology.
In short yes. But with some adaptation needed.
Posted: Sun Feb 18, 2007 4:50 pm
by aircooledtechguy
I have a lot of info and pics of my conversion on my site. I basically did this very conversion into my '66 E-Z Camper. Hope this helps. . . Good Luck!!