window scrapers

plumcrazee · Post by **plumcrazee** » Sat Feb 24, 2007 3:25 pm

any one know of some good outside window scrapers for a 74 412 need the chrome bit with good felt chanel to stop the warter geting in my doors??? got all but need some new bottom peices

matt

vwfye · Post by **vwfye** » Sat Feb 24, 2007 5:40 pm

i haven't looked at my car's door yet, but this made me think... does the door have drainage slots in the bottom like the t3 doors do?

MNAirHead · Post by **MNAirHead** » Sat Feb 24, 2007 5:41 pm

be sure to save all your clips and hardware "nibbly bits?"

The aftermarket stuff is horrid (clips and bits)

T,.

plumcrazee · Post by **plumcrazee** » Sun Feb 25, 2007 1:41 am

vwfye wrote:i haven't looked at my car's door yet, but this made me think... does the door have drainage slots in the bottom like the t3 doors do?

it has dranage holes yeas 2 in the middle i think dont know if there the same as yype 3 tho

albert · Post by **albert** » Mon Feb 26, 2007 3:24 am

yes it as 4 drain hole 2 in the midle and one in each coner , for the felt , take felt and chrome molding on the right side inside door and install that on the outside lefgth side door , and that make nice job ,, look with attention what i said ,, albert

plumcrazee · Post by **plumcrazee** » Mon Feb 26, 2007 11:12 am

hello again albert i sent you a email on the samba thanking you for the swaping the trim over information

cheers again

matt