Shoptalkforums.com

Just got my dynoresult on my 2,2WBX turbo.
big smile
260HP
353Nm (260LB/ft) torque.
stock valves/heads, almost stock camshaft, stock rods,crank etc.
15PSI boost.
megasquirted with IC on 98 RON pumpgas

So now it's time to do some real tuning this vinter....

wicked, nice one what revs you going to and what turbo you using?

thx!
don't have my paper's here , but MAX hp around 5700RPM.
Max torque a bit lower of course, but not so much due to a too big turbo making it spool a bit too late and not making good torque @lower RPM's. T3-T4 hybrid.

keeping he turbo and making the engine breathe more

crazy, you want more power what clutch set up you using? i've gone from a standard 215mm up to a standard 228mm as smaller one was not holding at all well. and i think my power is 150+ bhp

always want more Power
im using a 228mm 6 puck sinterclutch and stock pressureplate.

congratulations
is about time someone else is pushing the stock wbx to is boosted limits.
with the stock heads i found that 5500rpm is as much as is will take before the power drops off.
run 21psi and you will be up to 300bhp.

have a look at my stock 1.9 turbo post
the dyno sheet is no loading any more but the motor made 227bhp@4750 and 259ftlb@4500 with 14psi.

http://www.shoptalkforums.com/viewtopic ... sc&start=0

happy days

Don't see any pic's in the tread.
can u please mail me the dyno curve for comparsion=??
with my "NOS" hydros i have had the engine up to 7000Rpm.unstable oilpressure over 6500.-
stange u don't see more than 5000? maybe they are worn .
normaly i push it to ~6500.-

the DG engine has a lover duration cam than the DJ/MV engine , that maybe makes it produce power @ a lower RPM

got it to work



i had so many hard mile in the motor the springs could of got week, i cant realy remember is was over 4years ago

also the hydros were some cheep new crap from brasil

Will you be posting your chart so we can see what the power and torque curves look like?

Sick!

Yes, fastback, how about the chart, and some pics of the setup? What cam is in it?

Very nice !

I'm so exicited about my own SC project now, can't wait !

Br.
Rasmus

Nice!, I hope that I can see all 260hp in full use at bugrun -08

//Rydh

hi rydh!
very nice numbers on your 2,1 also!!
next year i hopefully see 350hp

here's the dynopull. note the Torque.. there's a whole lot'a torque missing in the lower RPM'S. due to the toobig of a turbo.
I tested with a smaller T3 and it spooled up almost 800RPM earlier.

how's this holding up? also can you tell me where you got hold of your clutch disc from as while i have the engine out on mine and am rebuilding/uprating i'd better make sure i sort that out to