EDIS boo boo

[Alexander_Monday]

Ok, Ok I am a dumb a$$.
Welded a new trigger wheel / pulley combo, but got it back a$$wards.
The missing tooth is 180 degrees out of phase.
It is a hub / pulley unit with 6 attaching bolts, so I could reverse BDC & TDC, but.....
Is there any reason I can't just reverse coil A & B wires?

[Rikard]

It should work to swap the A & B wires and it is pretty easy to check.

If you have cyl 3 or 4 at TDC, the missing tooth should be 90 degrees ahead of the vr-sensor.

Rikard

[Alexander_Monday]

Thanks.

I thought so, but I wanted a reality check since I screwed it up in the first place.
I am conveting from NA carbs & MJ ignition to MS FI & boost at the same time, so just one more thing in the pot that could cause a headace.

[Turbo_Manx_Maniac]

If the wheel is steel, can you cut off the tooth and weld it back in the right spot?

[miniman82]

That's redneck....

I like it!

[Alexander_Monday]

My previous VR set up was redneck

[Turbo_Manx_Maniac]

That's redneck....

I like it!

LOL, ask me how I know this works.....

[jaywiz1977]

My previous VR set up was redneck

thats not funny! that is exactly how i was going to hold my vr in place till i got it all tuned in!Where did ya get the wheel with the holes?

[Alexander_Monday]

Modified Berg pulley.

http://www.thesamba.com/vw/forum/viewtopic.php?t=318526

http://www.autosportlabs.org/viewtopic.php?t=1968