Page 1 of 1
EDIS boo boo
Posted: Mon Apr 11, 2011 4:20 pm
by Alexander_Monday
Ok, Ok I am a dumb a$$.
Welded a new trigger wheel / pulley combo, but got it back a$$wards.
The missing tooth is 180 degrees out of phase.
It is a hub / pulley unit with 6 attaching bolts, so I could reverse BDC & TDC, but.....
Is there any reason I can't just reverse coil A & B wires?
Re: EDIS boo boo
Posted: Wed Apr 13, 2011 3:59 am
by Rikard
It should work to swap the A & B wires and it is pretty easy to check.
If you have cyl 3 or 4 at TDC, the missing tooth should be 90 degrees ahead of the vr-sensor.
Rikard
Re: EDIS boo boo
Posted: Wed Apr 13, 2011 5:00 am
by Alexander_Monday
Thanks.
I thought so, but I wanted a reality check since I screwed it up in the first place.
I am conveting from NA carbs & MJ ignition to MS FI & boost at the same time, so just one more thing in the pot that could cause a headace.
Re: EDIS boo boo
Posted: Thu Apr 14, 2011 9:25 pm
by Turbo_Manx_Maniac
If the wheel is steel, can you cut off the tooth and weld it back in the right spot?
Re: EDIS boo boo
Posted: Thu Apr 14, 2011 9:39 pm
by miniman82
That's redneck....
I like it!
Re: EDIS boo boo
Posted: Fri Apr 15, 2011 5:11 am
by Alexander_Monday
My previous VR set up was redneck
Re: EDIS boo boo
Posted: Fri Apr 15, 2011 3:28 pm
by Turbo_Manx_Maniac
miniman82 wrote:That's redneck....
I like it!
LOL, ask me how I know this works.....
Re: EDIS boo boo
Posted: Wed Apr 27, 2011 7:30 am
by jaywiz1977
Alexander_Monday wrote:My previous VR set up was redneck
thats not funny! that is exactly how i was going to hold my vr in place till i got it all tuned in!Where did ya get the wheel with the holes?
Re: EDIS boo boo
Posted: Wed Apr 27, 2011 9:46 am
by Alexander_Monday