full lockup of vacuum/centrifugal advance of DJ distributor

[riseabove]

How do i do this in a good way ? i have a spare one that i want to use as one of two triggers in my upcoming ms install on my rallycross wbx engine.

Regards
Dann

[Steve Arndt]

The cleanest is sell the nice 1.9 distributor and replace it with a 2.1. It is already locked, and about half the height.

[Steve Arndt]

Your 1.9 dizzy has more value than a 2.1. Don't wreck it by welding the advance.

[riseabove]

But my 2.1 distributor from a "DJ" engine has vakuum advance in it. the bosch part# for the distributor is 0237 022 053 if that helps.

Regards
Dann

[Piledriver]

Europe got different combinations...

The late model FI version we got has no mech or vac advance, it's just a trigger.

The "full featured" setup you have should stay together and working as it's a HUGE upgrade for anyone sticking with carbs.

[riseabove]

but what about if i have a spare distributor just lying around from a previous engine ?
anyone have pictures of where to weld or what to do ? i WILL keep my complete injectionsystem as a unit complete with wiring harness if i ever want to go back to digijet....

[sideshow]

You can safety wire the weights w/o ruining anything. Same could be said for a drop of JBweld or like epoxy.

[riseabove]

i will that a try and hope for the best then

Regards
Dann

[tmatre]

This is how I modify my distributors.
http://forum.earlybay.com/viewtopic.php ... 6&start=80

[riseabove]

This is how I modify my distributors.
http://forum.earlybay.com/viewtopic.php ... 6&start=80

THANK YOU !!! this was EXACTLY what i was looking for !!!

tack så mycket , jag visste att någon nordisk människa skulle komma med lösningen till slut ! tackar varmast från Sverige !

Regards
Dann