Page 1 of 1
Some oxyboxer questions
Posted: Sat May 03, 2014 12:21 pm
by Rob Habets
Hi,
what's the correct head stud pattern for the barrels and cylinderheads from a type 1?
Which is the right type of Loctite threadlocker for the offset headstud inserts?
Regards, Rob
Re: Some oxyboxer questions
Posted: Mon May 05, 2014 12:34 pm
by Rob Habets
Anyone?
Re: Some oxyboxer questions
Posted: Wed May 07, 2014 5:11 am
by riseabove
Rob. Here on Oxyforums things tend to move slowly ..... extremly slow.....
i only have a readymade drill-guide and no solid measurements do go from. i can make rough measurements out of that as i have only borrowed it from a friend.
Re: Some oxyboxer questions
Posted: Thu May 08, 2014 5:21 am
by grelland
I can not answer directly, but what I did was to make inserts for the case which were 3mm offset drilled, so that means that the diameter of the head stud pattern type 1 heads have a 6mm smaller diameter than the wbx.
Re: Some oxyboxer questions
Posted: Thu May 08, 2014 10:01 am
by tmatre
This is in Norwegian, but I think you (with help from google translate) will find what you need.
http://www.vwnorge.no/index.php?topic=40863.60