Shoptalkforums.com

Posted: **Sat Apr 20, 2019 11:42 am**

So should li drill tap and slap a Zerk in there?

Posted: **Sat Apr 20, 2019 3:15 pm**

More importantly. Did you weld that tab on for the trans? Dang that's a nice one!

Posted: **Sat Apr 20, 2019 3:38 pm**

Gotcha, thought so but may I see don’t so thought I’d ask. I did

, slowly getting better. It helps having a helmet I can actually see the weld happening vice a bright spot where I’m hoping to weld.

Posted: **Sat Apr 20, 2019 5:22 pm**

Never seen the inner pivots get a zerk

Posted: **Sat Apr 20, 2019 6:25 pm**

You will now. See what it does.

Posted: **Tue Apr 23, 2019 7:56 am**

I never bother, by the time the grease is gone the bush is usually sloppy and wants changing anyway

Posted: **Fri May 03, 2019 9:40 am**

I zerked mine!! Works good. I'll post a pic later

Posted: **Fri May 03, 2019 12:10 pm**

fordfreak wrote: ↑Fri May 03, 2019 9:40 am I zerked mine!! Works good. I'll post a pic later

I could tell in mine from dry to greased. I’ve always ran them dry. Also hoping this will help there be no chance of the torsion bolt backing out.

To Zerk or not to Zerk that is the question