Page 1 of 1
Identifying lifters help
Posted: Sat Nov 09, 2019 5:15 am
by farmer rob
I wondered if anyone could identify a set of lifters for me. They weigh 94 grams and have 29mm feet. They came with a performance engine I bought in pieces and I wondered if they were matched to an Engle cam, all the bit's are new.
Many thanks Rob
Re: Identifying lifters help
Posted: Sun Nov 10, 2019 11:31 am
by Bruce2
Got a pic?
At 94g, they sound like Scat heavyweight lifters.
Re: Identifying lifters help
Posted: Sun Nov 10, 2019 2:24 pm
by farmer rob
Thanks for the reply! The chap I bought it off thought they were scat lifters but all the scat one's I have found so far on-line, were lighter or didn't show a weight. I thought I would use CB lifters on this but thought I could use them on something else if I could Identify them. I will post a couple of photo's tomorrow if you think it would help.
Cheers Rob
Re: Identifying lifters help
Posted: Mon Nov 11, 2019 7:05 am
by farmer rob
See if this works, not posted a photo on here for a while lol
The original VW lifters I have seem to have feet about 5mm thick, these are tapered, about 3.5mm on the edge and about 4.75mm by the upright
Cheers Rob
Re: Identifying lifters help
Posted: Thu Nov 14, 2019 11:28 pm
by Bruce2
Stock lifters are 82g. Scat "Lightweight" lifters are 94g. That is why I call them Scat heavyweight lifters.
Re: Identifying lifters help
Posted: Sat Nov 16, 2019 1:45 pm
by farmer rob
Many thanks Bruce
Rob