Wasser fits in 914...Confirmed
Posted: Sat Apr 19, 2003 10:38 am
There has been a running thread on the 914 forum, and some mistaken info was posted saying a wasserboxer is too wide to fit between the suspension consoles of a 914.
http://www.shoptalkforums.com/viewtopic ... c&start=30
Last night, I jacked a junk wasser into my junk 914, and there is NO clearance issue whatsoever.
It fits fine.
Adjusting the valves might even be easier vs a T4, assuming it's required on hyd motors. (not often)
Tuna posted my lowly pics on his site,
http://www.tunacan.net/wasserboxer/914/
(Thanks, Tom!)
http://www.shoptalkforums.com/viewtopic ... c&start=30
Last night, I jacked a junk wasser into my junk 914, and there is NO clearance issue whatsoever.
It fits fine.
Adjusting the valves might even be easier vs a T4, assuming it's required on hyd motors. (not often)
Tuna posted my lowly pics on his site,
http://www.tunacan.net/wasserboxer/914/
(Thanks, Tom!)