Shoptalkforums.com

Does anybody have the Bug-Me pan replacement video that they would be willing to loan (I'll return it in a week), sell (cheap) or copy (I'll pay for the tape and shipping)? I don't need entire 1/4 pans: just a few areas in which I can make my own pan parts. But I'd really like to study the method since I have never done this before. BBlide@earthlink.net BIll

Bill if you have a wire feed welder you can easily replace any pansections that you can cut a patch section for. Its not that bad. Just remove the unwanted section .Then make a template that nicely fits the opening then transfer that to the sheet metal to be used. You really can`t screw it up too bad. Good luck. Bob Ingman