Page 1 of 1
wxb inlet manifold
Posted: Thu Oct 23, 2003 5:23 pm
by sparkyshep
can any one advise me of a supplyer of a inlet manifold for my 2.1 wxb engine i wish to run either weber idf,s or dcnf or ida,s but they are a bit pricey for me please help as i looked at a type 1 manifold and the inlet ports where a lot smaller thane my wbx also are type 4 lifters the same size as type 5 lifters
Posted: Sun Oct 26, 2003 11:58 pm
by Wally
Hi,
Bernd Ahnendorp (
www.ahnendorp.com) stocks manifolds for the wbx heads to IDF/DLRA stud pattern. They may not be on the site tho.
Greetings,
Walter
re manifold
Posted: Mon Oct 27, 2003 9:32 am
by sparkyshep
thanks for the help on the manifold supplyer i will give them a try thanks steve
Posted: Tue Oct 28, 2003 1:33 am
by marcotheturbosteamengine
use CBs big beef manifolds and port them, yes the T4,T5,T25 use the same lifter but not the same cams!
good luck