I was kind of curious if there any inline 4 swap threads. Knowing that they might be another odd swap someone has done it.
I'm concerned with conversion to VW tranny or complete powertrain swap.
any vtec swap thread?
-
supaninja
- Posts: 1658
- Joined: Tue Sep 14, 2010 12:48 pm
Re: any vtec swap thread?
I haven't seen too many honduh swaps in a t3 but here is my favorite in a bug http://www.shoptalkforums.com/viewtopic ... 9&t=122882
I have measured out the dimensions of the k20 in my Si and the engine bay in my notch and it will fit without cutting up the body, just won't be able to close the engine lid. KEP makes an adapter, and if you plan on boosting it then you'll NEED a built bus tranny.
When the funds are available and I decide to go full darkside with my build, then i'll I'll be stuffing a k20z3 or k20a2 in there.
I have measured out the dimensions of the k20 in my Si and the engine bay in my notch and it will fit without cutting up the body, just won't be able to close the engine lid. KEP makes an adapter, and if you plan on boosting it then you'll NEED a built bus tranny.
When the funds are available and I decide to go full darkside with my build, then i'll I'll be stuffing a k20z3 or k20a2 in there.
'65 notch w/ a squirted type 4
http://supaninjanick.wordpress.com/
'68 "Zombie Response Vehicle" Westy
viewtopic.php?f=14&t=140387
-
adjunog
- Posts: 71
- Joined: Wed Jun 03, 2009 10:29 am
Re: any vtec swap thread?
The rotary sounds awesome too.